Failure to follow these instructions may increase the risk of injury in a collision. Give your full attention to driving and to the road. Ford strongly recommends that drivers use extreme caution when using any device that may take their focus off the road. Press and hold the rocker control to adjust accelerator and brake pedal toward you or away from you. On 5—passenger vehicles, the carpeted floor lid can be used as a kneeling pad. For less lumbar support, turn the lumbar support control toward the rear of vehicle. You may select display features on the message center for a display of status.
Many lights will illuminate when you start your vehicle to make sure the bulb works. Ensure that the vehicle is on or the ignition is in accessory mode. In certain lateral collisions, the airbag on the side affected by the collision will be inflated. Turn ignition to the on position. Rotate the bulb socket counterclockwise and remove it from the lamp assembly.
Instead they figured that crawling under the truck to check the fluid with tools u probably dont have would be a much better method. Lift the seatback toward the rear of the vehicle. Pull the bulb straight out of the socket and push in the new bulb. Follow your local authorized standards for disposal. After a collision, if the engine cranks but does not start, the fuel pump shut-off switch may have been activated. Put the dipstick back in and ensure it is fully seated. Note: If any door, the liftgate or the liftgate glass are not closed properly, the lamps will not flash.
If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount for towing to the nearest dealership within 35 miles. Note: When you turn off the speed control or the ignition, your speed control set speed memory is erased. Make the final connection of the negative - cable to the ground stud located toward the front of the vehicle forward of the battery on the radiator support. Pull up on the handle and push the seatback forward toward the front of the vehicle. It must be below the maximum trailer weight shown in the chart. If you change your wheel size, you will have to purchase new tires to match the new wheel diameter. To return the seat to the upright position E-Z entry equipped seats : 1.
Refer to Windshield washer fluid in the Maintenance and Specifications chapter. Check the appropriate fuses before replacing any electrical components. Refer to scheduled maintenance information. Power steering fluid reservoir 8. Note: Always replace a fuse with one that has the specified amperage rating. To avoid activating the Belt-Minder feature for objects placed in the front passenger seat, warnings will only be given to large front seat occupants as determined by the front passenger sensing system. Note: Large metallic objects, electronic devices that are used to purchase gasoline or similar items, or a second coded key on the same key chain may cause vehicle starting issues.
It can also warn you in the event the system is no longer capable of functioning as intended. If your vehicle has tires of a different size than the size indicated on the vehicle placard or tire inflation pressure label, you should determine the proper tire inflation pressure for those tires. A display will appear at the bottom of the screen indicating the brightness level. Do not tow with a slingbelt. By law, vehicle owners and anyone who manufactures, repairs, services, sells, leases, trades vehicles, or supervises a fleet of vehicles are not permitted to intentionally remove an emission control device or prevent it from working. Vehicle line, series, body type 4.
Note: Do not use the running boards, front and rear hinge assemblies, running board motors, or the running board underbody mounts to lift the vehicle with the. If you crawl underneath the front and look up you will be able to see it. Ford strongly recommends that drivers use extreme caution when using any device that may take their focus off the road. Do not drive if you smell exhaust fumes. To obtain reimbursement information, U. Press to scroll through various menus and selections. The childproof locks are located on rear edge of each rear door and must be set separately for each door.
The next two numbers or letters are the plant code designating where it was manufactured, the next two are the tire size code and the last four numbers represent the week and year the tire was built. This will damage the spare tire winch. Pull the bulb straight out of the socket. After returning the seatback to its original position, pull on the seatback to ensure that it has fully latched. Allow the seat to dry thoroughly.
Ford strongly recommends that drivers use extreme caution when using any device that may take their focus off the road. Do not attach safety chains to the bumper. An unlatched seat may become dangerous in the event of a sudden stop or collision. Choose a booster that keeps the lap belt low and snug across the hips, never up across the stomach, and lets you adjust the shoulder belt to cross the chest and rest snugly near the center of the shoulder. Insert the dipstick fully, then remove it again. Engine oil dipstick out of view 3.